DVD Case Template
Below is a
screenshot of a template of my DVD case, the guidelines show the dimensions of
the print out, with the spaces outside on the edge being the bleed area so that
no important parts of the graphics are cut off of the paper as the bleed area
is the bit that will get cut off, this is because the image is usually printed
larger. The dimensions of the DVD case template are as follows, the vertical
guide lines on the left and right, as well as the horizontal ones at the top
and bottom are 3mm from the edge too allow for a 3mm bleed area. The vertical
and horizontal guide lines in the very middle are just to show where the middle
of the template is, whereas the two lines on either side of the middle vertical
guide line shows the width of the spine, which is 14mm.
No comments:
Post a Comment